X9C104 (100K) Digital potentiometer 8Pin DIP

Introduction The Intersil X9C104P is a 100kΩ digitally controlled potentiometer offering 100 wiper taps and non-volatile storage of a tap point for subsequent power-on events. Digitally Controlled Potentiometer (XDCP™) digitally controlled (XDCP) potentiometers. The device consists of a resistor array, wiper switches, a control section, and non-volatile memory. The wiper position is controlled by a three-wire interface. The potentiometer is implemented by a resistor arraycomposed of 99 resistive elements and a wiper switching network. Between each elementand at eitherend are tap points accessible to the wiper terminal. The position of the wiper element is controlled by the CS, U/D, and INC inputs. The position of the wiper can be stored in non-volatile memory and then be recalled upon a subsequent power-up operation. The device can be used as a three-terminal potentiometer or as a two-terminal variable resistor in a wide variety of applications ranging from control to signal processing to parameter adjustment. Pinout X9C104 8 LD PDIP . Features Solid-State Potentiometer Three-Wire Serial Interface 100 Wiper Tap Points – Wiper Position Stored in N on-volatile Memory and Recalled on Power-up 99 Resistive Elements – Temperature Compensated – End-to-End Resistance, ±20% – Terminal Voltages, ±5V Low Power CMOS -VCC= 5V – Active Current, 3mA max. – Standby Current, 750μA max. High Reliability – Endurance, 100,000 Data Changes per Bit – Register Data Retention, 100 years X9C104 = 100k https://www.intersil.com/content/dam/intersil/documents/x9c1/x9c102-103-104-503.pdf “X9C104 (100K) Digital potentiometer 8Pin DIP”